Instructions to tie a tie

Tie is a material worn around the neck under the collar with a bow in front. At first it was the privilege of belonging to a higher position, wearing a tie. However, regardless of location, it has become fashionable to wear a tie or a tendency for men. If a business meeting, the official party line, functions, connections goes well with all types of occasions. In most cases, a draw is the most important when you go to a job interview. There are different types of tie knots, you can connect easily. Nodes as the half Windsor knot Windsor knot, four-in-hand knot, nice / Shelby nodes are frequently used. 1. Windsor Knot is wide triangular knot necklace worn shirts and are widely hoped that during the official ceremonies. To make a Windsor knot, you must follow these instructions: a. Insert the tie under the collar, so that the widest point is longer than the thin end and thin end level until the end. b. Now, break the loop between the collar and tie and were therefore dropped the hanging. c. Again, pull the end of the scale under the thin part of the left and then back out of the loop. d. Now they finally broad front, from left to right. e. Disconnect the wide end of the cycle and bring to the front of the node. f. With the help of your two hands, pull the knot and drag it to the neck. 2. Half-Windsor knot is a triangular way more formal than four-in-hand knot: a. To make a half Windsor knot, placed at the end range of the tie under the collar with a final broad and fine tip plus the passage from 'other. b. Bring the wide end around and behind the narrow end and then go ahead. c. Before you draw on the way through the loop, then bring the wide end around front, on the thin side from left to right. D. Again and take a break in loop and then bring the end more important, through the node. Tighten the knot knot under the collar.